X-Mozilla-Keys:
Bill Freeman wrote:
Mike,
Thanks for the clarification. I had no idea that the mount was so
integrated,
snip for ID
How about cutting the main eng mount tubes about 2" from the firewall (assuming
this leaves the gear mount OK, otherwise 2" fwd of the gear mount).
Slip a 3" long piece of the correct ID 4130 tube over the existing stub,
and bolt it in place with two AN4 bolts at 90 deg to each other. Now insert
NEW pieces of 4130 into these sockets and bolt them into place, also with
two AN4 bolts. Now bend, weld etc as req'd to mount the Mazda.
Gary Moir writes:
1) Bolts thru thin tube need bushings to allow full
torque w/o crushing the tube.
2) Structural bolts need tight hole tolerances, maybe reamed.
3) Tubes in sockets introduce punch loads & stress concentrations and need
adequate L/D ratios.
4) Bent tubes aren't trusses, they're bending frames, and change
the design requirements for thickness and end attachments.
Apparently the primary problem is your lack of welding skills. This may be
over blown. snip ...
I have a friend who can weld it for the price of a couple of beers.
Don't forget to inspect the weld! Surface flaws can be detected with good dye
penetrant (preferably UV) and are most critical, but cosmetically covered internal
flaws are worse because you need good X-rays to find them. (I've done safe-life
fracture mechanics analysis for 3 NASA flight safety reviews and lots of parts.)
Certified welding is worth the price when it's your neck.
There are eight or nine other tubes in the stock
mount that can be done away with.
Don't be too casual about cutting and discarding. Analyze all the cases. Here's Moir's
rule: Any structure that is Optimized for an incomplete set of loads will fail when
exposed to the omitted load cases.
BTW. I'm a MSME, structural engineer, so I see this sort of stuff all
the time.
Glad to see your qualifications. I'm an Aero & Astro Engineer a few credits short of
my MS, with many years of structural & dynamic analysis experience.
Gary Moir
p.s. Take a look at my bio on the Wright Flyer web sites below.
http://quest.arc.nasa.gov/aero/wright/team/moir.html
` \\\|///
` \\ ~ ~ //
` ( @ @ )
***************************oOOo*(_)*oOOo**************************
*** ***
*** Gary A. Moir & Associates, Inc., dba GAMA Ingenuirity ***
*** emailto: ingenuir@ix.netcom.com ***
*** Phone & Fax 310-378-7076 ***
*** Check out the ***
*** AIAA Wright Flyer Homepage! ***
*** http://www.alumni.caltech.edu/~johnlatz/1903.html ***
*** ***
******************************************Oooo.*******************
` .oooO ( )
` ( ) ) /
` \ ( (_/
` \_)
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org