Subject: Mike Wills aluminum plate motor mount.
From: Paul
Date: 11/4/1999, 4:31 PM
To: zz

X-Mozilla-Keys:                                                                                 
Mike Wills wrote:

At 06:15 PM 11/3/1999 -0800, you wrote:

Mike I have the RV4 drawings. You can mount the rad under all
the necessary tubes. If you mount the hat section under the last rotor
housing (the one nearest the front of the engine in the airplane) you
are not limited by the motor mount. The ring gear and end housing
will limit how far up you can get and tilt the rad.


Paul,

  As you know I had quite a drawn out email exchange with Fred Moreno
recently regarding my cooling system configuration. The conclusion reached
was that the best configuration for maximizing rad area was to arrange 2
rads in a V as seen from the front. This is similar to what Alan Tolle had
on his RV3. But on Alan's airplane the engine was so far forward from the
firewall the rads were behind the engine. That wont work for me. I had
planned to put the rads under the oilpan. In this configuration with my
previous mount design I would be able to get 2 rads in there approximately
12 X 20 X 2. But if I go with a mount as you have shown the mount tubes
coming up from the lower corners  of the firewall to the mount hat section
interfere with rad placement. It appears I will be forced back to a single
rad located horizontally under the engine. This is my least desirable
option as the room for a diffuser appears to be pretty limited. And I think
I could get much more rad surface area with the V arrangement.

  Ideally I would like to keep the mount tubes parallel to the eccentric
shaft and as close to the oil pan rails as possible to maximize the room
under the engine. Kind of like the bed mount on a P51. But after what Ive
read hear it appears that would be a poor design choice. I'll know more
about what I can and cant fit after I get a chance to fiddle around with
the PVC.

Mike Wills

Are you sure there is 12 inches of vertical height under the engine?
It does not look to be that much from the RV4 drawings? It looks 
more like about 8 or 9 inches. 

You more less have to go with what Van designed as hard points on the
firewall. Major changes to the fueslage structure would be required if
you attempted to feed the loads into some place other then where
they are now. You could still get your V congiguration rads in there
if you could somehow figure out how to stiffen the mount laterally.

That does not look promising given the RV4 narrow configuration without
some sort of diagonal stucture under the engine that terminates at the 
existing firewall hard points.

IMHO the choices are one angled rad under the engine, several rads
in the rear fuselage or a larger area, thinner radiator,
greater angled version of what Tracy Crook has done with his RV4. 
That of course means keeping the cheeked cowl. 

Thinking about it a bit more if you can angle those 12 inch high
rads in both vertical and horizontal planes under the engine I 
think I might have a solution. Two brace tubes orginating at the center
of the cross tube under the pan and terminating at the lower firewall
hard point would serve to stiffen the mount laterally. I will make
a drawing and up load it.  A side exhaust will be essential.

BTW the high angle rad is working great. I just measured the flow
and if anything I over did the curve  with too little clearance at 
the back end. The flow sensor is also working great.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org