Subject: Mike Wills aluminum plate motor mount.
From: Paul
Date: 11/4/1999, 4:32 PM
To: zz

X-Mozilla-Keys:                                                                                 

Gary Moir writes:

 1) Bolts thru thin tube need bushings to allow full
    torque w/o crushing the tube.

 2) Structural bolts need tight hole tolerances, maybe reamed.

 3) Tubes in sockets introduce punch loads & stress concentrations and need
    adequate L/D ratios.

4) Bent tubes aren't trusses, they're bending frames, and change
   the design requirements for thickness and end attachments.

  I immediately wrote this plan off. If Im going to have to cut the
existing mount up anyway I will assemble a properly welded structure in its
place.


: Any structure that is Optimized for an incomplete set of loads will fail
when
exposed to the omitted load cases.


Gary Moir


I'm now looking at something very similar to Paul's suggested RV4 mount
scheme which he posted here previously. Your comments please on this design
Gary?

Mike Wills


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org