Subject: Abel's new 798 HP 13B
From: Paul
Date: 11/5/1999, 5:13 PM
To: zz

Abel Ibarra's new two rotor 13B engine hits 798 HP at
the rear wheels no less with the stock intake manifold.
Extrude honed of course. Side street ports too. 

Some specs on the engine:
Garret T55 based turbo from Fast Trax at 35 to 40 psi.
P-trim turbine wheel. Three inch exhaust pipe.
HKS waste gate and HKS EVC-IV controller.
Looks like dual pop off valves on the intake
manifold. No intercooler as far as I can tell.
Must be pumping alcohol in there like no tomorrow
to keep the charge cooled.

It is using an enlarged RC Engineering throttle body.

3 mm ceramic apex seals.

Abel claims the NOS is only worth another 75 to 100 HP.

The fuel line is -10 and there are eight 160 lb per 
hour injectors.  A Weldon 2025 fuel pump is used.
with a 5/8 fuel rail. Motec M4 Pro fuel injection 
computer and four MSD 7AL-2 ignition systems
with Pro Power-2 coils. 

Not bad for a 200 pound basic engine.

This engine power level is not something you would put in an 
airplane unless you were racing at Reno AND you had
a REAL strong PSRU!.

The tube frame, carbon fiber body car has gone 170 MPH
in 7.90 seconds in the 1/4. 

Read all about it in this months (Dec) Turbo and High Tech 
Performance mag.

I am going to talk to these guys at Fast Trax in Torrance
(310) 782 3528 for my Turbo. I am getting tired of the waiting 
on Turbonetics.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

abelrx7f.jpg