This is a subtle improvement on the RV4 motor mount.
Since moving the hat section under the rotor housing gets it closer
to the heat of the exhaust I moved most of the rubber
part of the mount under the steel hat section. It would
still be a good idea to make your own rubber parts out
of 1/8 silicone sheet rubber and red RTV glue particularly for
the narrow RV4 mount.
Doing this I discovered an aluminum block instead of a welded
structure in this area would kill a couple of birds with one...
The diagonal brace tube yoke that attaches to the bell housing
bolt on the upper end can now be merely bolted to the aluminum
block that will take most of the 6 to 9 G pull up loads on the
lower end. Much easier to fabricate and maintain.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org