Subject: oil and water coolers
From: Paul
Date: 11/5/1999, 2:32 PM
To: zz

X-Mozilla-Keys:                                                                                 
Fred  wrote:

To further the confusion:

In transferring heat from fluid A to fluid B across a wall, the rate of heat
transfer is proportional to the temperature difference between A and B, the
area between them, and the heat transfer coefficient for the respective
fluids.  (Temperature drop in the wall is generally negligible.)
Transferring heat from oil to coolant, it is true that the temperature drop
is much less than transferring to air, but the heat transfer coefficient for
air in a good radiator or oil to air cooler is about 20-30 btu/square foot
per hour per degree F.  On the coolant side it is about 1000.  So the very
high heat transfer coefficient more than makes up for the low delta T and
permits also a reduction in the area if there is liquid on both sides.  (Oil
is not quite so good as coolant, but still much better than air.) .

Based on the few oil to coolant heat exchangers I have seen, the problem is
that they are not large enough for the rotary which dumps so much of its heat
to oil.   However, with a big enough liquid to liquid heat exchanger, it
should work just fine. Aeroquip makes one for race cars, but as I recall it
would take 2 or 3 to do the job.  See their performance charts and check it
out.

 Otherwise, I suggest (for simplicity) that users consider the combined oil
to air and coolant to air heat radiators made by several suppliers.
Essentially two heat exchangers in one frame.  Collect air in one inlet, pass
it thorugh one diffuser, then over the radiator, then through the cowl for
ventilation, then out.

The key is to make sure the oil portion is large enough for the heat load
anticipated.  Using the figures provided for heat loss previously cited here,
you should be able to give the supplier a specification (X btu/hr from
coolant at 190F and A gpm, and Y Btu/hr from oil at 210F at B gpm) and have
the supplier provide a design to do the job.

Be sure to share your findings!

Fred


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org