Mike Wills wrote:
Paul,
Your mount using a hat section shows a Barry bushing part number 22003-3.
What are the various dimensions on the bushing...hole size, overall
thickness, etc..? Can you point me at a distributor for these or do I need
to go direct to Barry?
On a slightly different note since Ive been swayed to a tubular mount
what is the consensus opinion on heat treating after the welding is done?
Is it necessary or is normalizing the weld clusters sufficient?
Mike Wills
You better be sitting down when you hear the price
$6.98 each. I had to buy four to meet the $25 minimum :-)
I bought mine from a distributor in Chatsworth CA called
Fairchild Fasteners. 1 800 992 4444
Part number is 22002-14 for Neoprene.
Load rating at about half deflection is 170 pounds apiece
axial and 75 pounds radial. Deflection at this load
rating is about 0.020. Axial spring rate is
about 6500 pounds per inch.
Barry has silicone but they are special order and that would
cost a bunch. I think you can make your own by punching
out donuts from 1/8 inch thick sheet silicone rubber and
gluing them together with red RTV silicone. I notice that
red RTV sticks extremely well to silicone rubber sheet.
Rubber sheet like this is avialable from AC Spruce for
engine baffling.
I would do this Mike for the RV4 because the mounts are
really close to the engine and the exhaust and Neoprene
is only good for about 200 F. Silicone is good for 300 F
continuously.
In my case the mounts are 8 or 10 inches away from
the engine so Neoprene will work fine.
Heat treating is nice but you need a really good fixture
to keep everything in alignment. Most people settle for
normalizing. We are not building space craft or rocket ships
here. These mounts using 3/4 .049 tubing are at least
50% over designed.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org