Subject: Mike Wills new motor mount?
From: Paul
Date: 11/9/1999, 6:14 AM
To: zz

X-Mozilla-Keys:                                                                                 
Bill Freeman wrote:

Here is another excellent way of doing a motor mount for an RV.
It works well with any design that has the upper firewall
hard points up near the top of the cowl.

http://robertr237.virtualave.net/RandomIdeas/Oshkosh0021.JPG

The picture was taken by Bob Reed at OSH this past year
of the Power Sport display. I would however make all
the rubber parts out of silicones as they are in close
contact with the engine.


Paul Lamar


Watch out for mount tubes real close to the exhaust.  The heat
will accelerate corrosion in the mount tube ---  right Paul?

(this is known by all C182 owners, since the mount is too close
to the exhaust system)

Bill

Yes. I had that problem with my 182. I had to replace some tubes. 

I think the main problem with the Cessna was they wrapped
the tubes with asbestos cloth which then trapped moisture.
I think a simple stainless heat shield held on with hose
clamps should work better. For that one tube that goes right down
along side an exhaust pipe in the RV4 I would go up in wall 
thickness to .065.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org