Subject: Mike Wills new motor mount?
From: Paul
Date: 11/9/1999, 8:01 AM
To: zz

X-Mozilla-Keys:                                                                                 
Bill Freeman wrote:

                SNIP

Watch out for mount tubes real close to the exhaust.  The heat
will accelerate corrosion in the mount tube ---  right Paul?

(this is known by all C182 owners, since the mount is too close
to the exhaust system)

Bill

Yes. I had that problem with my 182. I had to replace some tubes.

I think the main problem with the Cessna was they wrapped
the tubes with asbestos cloth which then trapped moisture.
I think a simple stainless heat shield held on with hose
clamps should work better. For that one tube that goes right down
along side an exhaust pipe in the RV4 I would go up in wall
thickness to .065.

Paul Lamar

A heat shield is an excellent idea.  I didn't know that Cessna
wrapped the mount tubes.  Mine are not wrapped but it
has a fairly nice set of  home-made radiation shields made from
sections of  large diam aluminum tubing, mounted with hose
clamps and spacers.  My tubes look good, but could use a bit
of repainting.

Bill


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org