X-Mozilla-Keys:
Peter Johnson wrote:
Hi Butch. To describe the situation further, The rad was located beneath
the engine in a manner which has been discussed here frequently. The air
flow for the rad was in through a scoop located low on the cowl, up through
the rad, out of the rad and up over the engine, then aft and out through
cowl cheeks located on each side. The setup is slick, smooth and very
effective cooling wise. The engine combustion air was being drawn from
within the cowl. Each time the thermostat opened, the increase in temp. of
the cooling air exiting the rad and being drawn into the carb created the
affect of carb heat being applied. The situation was quite troublesome to
find and was only discovered after enough time in the cockpit allowed for
some 'relaxed' gauge watching. This is the gist of what I know. Of where
the relief valve is dumping I do not know.
mailto:pjohnson@voyageur.ca
I find it difficult to believe most four cycle engines would suffer
from this. Carb engines run quite well with or without hot
air. Down on power yes but they run smooth. Fuel injection engines
compensate the mixture based on air density so they too should
have little trouble. I have nada, zero, no experience with two cycles.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org