X-Mozilla-Keys:
Don't underestimate the importance of induced
drag when you are pulling two or three G's
in the turns.
A P51 weighs about 7000 pounds empty.
I think we can build a turbo three rotor
under 1000 pounds. All other things being equal
like aspect ratio, wing loading, turn G's and
turn speed the RRR would have 1/7th of the
induced drag in the turns.
There is a close relationship between the empty
weight of an aircraft designed for a specific purpose
and the weight of the engine. The P51 and the Bearcat
were designed for range and armament. They are probably
over designed as racers.
We can do this because the power to weight ratio
of a turbo three rotor is much better than a Merlin.
Probably close to 3 HP per pound while the racing Merlin
is probably close to 2 HP per pound. The target weight
of the three rotor engine with alloy end housings would
be about 300 to 325 pounds. As I recall a Merlin is
about 1600 pounds. That works out to about
4.4 times the engine weight for the empty weight of
7000 pounds for the P51.
I think using carbon fiber we can get that ratio down
to about 3 or an empty weight of 900 to 1000 pounds
for the turbo three rotor RRR. Maybe even less.
Therefore:
If we only have 1000 HP the Merlin would need
7000 HP to keep up with us in the turns.
At best I doubt a racing Merlin has much more
than about 3500 HP. This is a very crude
estimate because it ignors flat plate drag.
The P51 might have a slight advantage in that
regard but overall it still will be at a large
disadvantage in the turns.
Weight is probably far more important at Reno
in unlimited racing then most people realize.
If there are any secrets to Nemesis's performance
this is one of them.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org