Subject: Rotary Reno Racer II
From: Paul
Date: 11/13/1999, 11:20 PM
To: zz

Russell Kent wrote:

Paul wrote:

Ugly as sin but what the hey? I imagine some people thought
the Gee Bee ugly in its day.

Some people still think the Gee Bee is ugly.  :-)

I think you should mount the top engine so that the power end is forward,
then the bottom engine so that the power end is rearward.  You'll need to
stagger the engines (to allow the belt room), which will give you a
desirable taper towards the front of the fuselage.  And plenty of room for
counter-contra-radiators (or whatever the official term is).

Russell Kent

OK Russell. Good idea! Here it is. A little hard to plumb the top
turbo but it could be done. Two large area V shaped rads in aft fuselage 
with P51 style side scoops and a common exit duct out the tail for 
thrust.

Over and under turbo three rotors. 2000 HP. 2500 pounds empty weight.  
Conventional counter rotating props 91 inches in diameter. Like Vance
says. Offset herringbone rubber belt 3.5:1 PSRU suggested by Chris
Cosman.

 Easy Reno unlimited winner.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

renora2.gif