Subject: Tuned intake for Canard Pushers
From: Paul
Date: 11/17/1999, 6:01 PM
To: zz

Perry Mick wrote:

Paul:

You were telling me I need a new intake manifold.  Even your coiled
up tuned manifold is quite large, 10 inches in diameter and 17 inches
long.

Do you see anything wrong with the approach in this diagram?  There
would
be a small bump above the spar, but it's in the longitudinal direction.

--
Perry Mick
perrym@teleport.com
Duckt N7XR
http://www.mickaircraft.com/duckt.htm


Nothing wrong with it Perry it should work fine. It is not "tuned"
however as you need four or six 18-24 inch long pipes depending on four 
or six port  engine.. terminating in a relatively large volume plenum 
chamber. Do you have room for that? The tuning idea is one rotor's 
worth of pipe(s) are sucking while the other is not so the
intake pressure pulse must travel a finite distance and then 
bounce back into the intake to have a slight supercharge
effect.

Taking the intake from the leading edge is good as you will 
get a ram effect. Dust and dirt could be a problem.

Perry-Micks-ram-air-intake.gif

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Perry-Micks-ram-air-intake.gif