X-Mozilla-Keys:
Howard Wilkinson wrote:
Paul:
I just got around to reading this thread, and I must take issue
with your answer to the question about using the turbo for cooling
air. You pointed out that turbos were designed to compress air and
that a great deal of heat was added in the process. However you
failed to mention that you can either push air through a radiator or
PULL it through. There is absolutely no reason on earth why a turbo
could not be used to pull air through a radiator... they do move a lot
of air, and the more fuel air mixture the engine is burning the more
air the turbo moves. Thus the more power your engine is putting out,
the greater the airflow your turbo would generate.... also the larger
the amount of waste heat the engine would generate. A properly sized
turbo would perfectly match airflow to heat dissipation requirements.
The air could not of course be then fed to the engine as the temp
would be too high.
I am not so sure a centrifugal blower like a turbo likes to suck :-)
I do know it likes to compress :-). Are you sure it just won't stall?
PL
I suspect however that an engine could be throttled down by
feeding it hot air at atmospheric pressure rather than by choking off
the airflow with the throttle.... there is a significant loss of power
when carb heat is applied, and that is very little heat. An
interesting thought.... Cold air for full power, progressively warmer
air (less dense) as power is reduced to cruise.... zero manifold
vacuum and 80% power maybe?? If it could be prevented from pinging
your pumping losses would be reduced and greater efficiency should
result. Perhaps an off beat idea, but something to think about.
Perhaps theromdynamics can be used to your advantage.
H.W.
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org