Subject: Firewall rubber motor mount for Cozy.
From: Paul
Date: 11/29/1999, 11:12 PM
To: zz

X-Mozilla-Keys:                                                                                 
norm doty wrote:

hi guys, im really confused.
why dont we use a frame or bed mount directly bolted to the firewall like
everyone else's airplane. then put the cushions between the motor and mount.
this way we dont  have the other problems that seem to be developing.
norm & monda
cozy IV #202
ford v-6 powered

There are plenty of examples of bed mounts on the ACRE NL web site.
http://home.earthlink.net/~rotaryeng/

The idea with this mount is it is somewhat simpler to build than a bed
mount as the rotary in general does not have suitable motor mounts built
in
like an aircraft engine. It is much easier just to bolt a few tubes
to it and put the rubber biscuits someplace else. The best place is the
firewall because all you need is about a 1-1/2 inch hole and the
firewall
itself serves as part of the mount. There is also an advantage in that
the loads going into the firewall are not as concentrated as they
are with bolt hard points. They are fed into the firewall over
an area of about a three inch diameter circle. This becomes a large
advantage for a composite airplane as the materials used are not
as hard as those used in metal airplanes. 

The problems are not as bad as they sound. All you need do is make sure
the firewall is well attached to the fuselage and it is thick enough
to support the rubber in shear. In the case of my KIS Cruiser there are
no 
problems. In the case of the Cozy I am not really sure as I have not
built one. In the case of the Variez and the LongEZ the loads go
into aluminum channels embedded into the fuselage structure so the 
firewall fuselage junction  would definitely have to be beefed up 
to take these loads. 

BTW the aluminum channels have been known to crack in the Variez.
This illustrates the difficulty of trying to feed concentrated
loads into a composite structure.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org