X-Mozilla-Keys:
Romulo Augusto wrote:
Bulent Aliev wrote:
The firewall on the Cozy is 1/4" plywood with one layer
of bid glass on each side.
Per plans hard points are 1X1" alum. imbedded in the ply.
Bulent
I assume the firewall is at least 5/8 of
an inch thick or you can add several layers of cloth to build it
up in the area of the rubber bushings to 5/8th to 3/4 of an
inch in thickness.
Paul Lamar
It will have to be thickened up with another layer of 1/4 inch ply on
both
sides about three inches diameter minimum. This is necessary so the
rubber
is working against the proper area. The shear and torque loads from
the engine is taken by this area of the rubber in the mounts.
The wood in the plywood donut hole should be coated with epoxy.
An alternative is a 1/2 inch plywood three inch diameter donut bonded
to the back of the firewall. The aluminum is un-needed and will
probably get in the way.
Paul Lamar
That is exactly my worries about a more powerfull/heavy engine on Cozy. The
design is aproved a lot ( for 180/200Hp engines) but I have my dubts if the
firewall and sides will resist for your propoused test ( lift the nose, by
aplication of weigth on the mount).
I think, your last suggestion sounds like a correct approach.
Romulo
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org