X-Mozilla-Keys:
For all you guys building composite airplanes this idea
might save you some time and simplfy the motor mount.
It needs a firewall that is 5/8 to 3/4 inch thick with a high
density foam or plywood core. The rubber mounts are installed
directly in the firewall making the tubing connection to
the engine much simpler. the ends of the tubes could be bolted
almost anywhere on the engine that was convenient.
The washer on both sides of the rubber mount must be at least
1/4 inch thick and two inches in diameter for a hard landing
other wise the rubber will pull or push right through the firewall.
The loads on the mounts are higher so it will probably be
necessary to go up a size or two on the rubber mounts.
It does not seem to be practical for aluminum airplanes.
Please comment on this as it is just an idea in early stages
of development.
Paul Lamar
Al Gietzen wrote:
Paul;
It could be a fine design approach, but a couple things come to mind from
way-back-when doing vibration analysis. Generally, you would like to keep
the vibrations isolated to as close to the source as possible; minimal
vibrating mass. The elastomer dampeners would be most effective with
minimum loading, and you might get higher amplitude, lower frequency
vibration back at the firewall than at the engine. Could be these would be
more likely to find resonance with the fuselage (just a guess).
Al Gietzen
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org