X-Mozilla-Keys:                                                                                 

Ken Powell wrote:

I would like to recommend that everyone who is using a bed mount to add
a heat reflector between the rubber motor mounts and the exhaust to
protect the rubber from the high temps.  I have noticed the the exhaust
side motor mount is usually broke on '86 and later RX7's, so this is a
definite possible problem as the recent posts on this subject suggest.

Ken Powell

Tracy Crook wrote:

True,  I used a 'low tech' approach and safety wired some aluminum foil
around the mount closest to the exhaust.  Same story on coolant lines near
the exhaust.  Does the job just fine.

Tracy Crook
rws@altavista.net
www.rotaryaviation.com

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org