Subject: Firewall rubber motor mount for Cozy.
From: Paul
Date: 12/2/1999, 8:33 AM
To: zz

X-Mozilla-Keys:                                                                                 
norm doty wrote:

yes the mounts were strong enough for the 250hp engines, the drive shaft to
the gear box froze up in its bearings and the engine was at full [tilt]. 

Almost nothing will tolerate that. One of the durability test's the car
manufacturers used for testing the front suspension was to get the 
wheel going 100 MPH or so and lock it up. Usually this resulted in
ripping 
out the front suspension. Depends on what seizes where. If the front
bearing seizes in a PSRU you will probably lose the prop. If the gears
seize you will probably twist off the input shaft and maybe the
attachment
of the PSRU to the engine. If the engine seizes you may lose the whole
works.
A safety cable is always a good idea on these kinds of airplanes. PL


the hull
and drive requirements between an airplane and boat are very similar, the
only real two differences are the medium that the prop is in (air/water) and
the cooling, in a boat we have unlimited cooling medium (water) a plane has
to use air.

but i wish you the best of luck, [on this mount? :-)] and i really hope 
this [mount] works out.
i really like the mazda engines, ive never had one blow up, ive had lots of
piston engines go though.
norm


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org