Subject: Piper tri pacer fuselage V6 STOL
From: Paul
Date: 12/6/1999, 11:14 PM
To: zz

Joa wrote:

Paul,

For the V6 the lower thrustline (he had two different height reductions
available) is 7" below the top mounting bolts (15" below top of firewall.)
His upper one is 3 1/8" higher than this so anyplace between  about 12" and
13" from the top of the firewall would be fine.  I'm more worried about the
height (need it about 5" under the cowl) though since I want the induction
to fit under the stock cowl.  Not so worried about *length* since I can make
a new nosebowl and will probably have to anyway.  Pretty sure I can use the
stock aluminum part of the cowl.

Tell you what, if you could do me a favor and just send me any scale drawing
you have of the 13B with the location of the CG (with or without the
redrive, I can calculate what it will be with mine) then I'll draw it up in
the proper location.  My disadvantage is I can't find a darn drawing and I
don't have an engine in front of me or close by.    I can take about any
.dxf or .dwg too.

Thanks!

Joa
______________________
PIW Engraving and Milling
      "Affordable CNC"

OK Joa you should have no problem with this DWG file as it is
upward compatible with all later than ACAD 11 versions. 
Let me know if it does not work and I will send it in zipped 
DXF form.

It is for a GlasStar which is not that much different than 
a Piper Pacer. It is the one I would modify anyway for the Pacer.

It is also on the web site in GIF form.

BTW the rad duct/diffuser shown needs updateing so don't build
it like that.

Paul Lamar


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org