Subject: Piper tri pacer fuselage V6 STOL
From: Paul
Date: 12/6/1999, 10:13 PM
To: zz

X-Mozilla-Keys:                                                                                 
Peter Cowan/Lexi Cameron wrote:

Sounds like you are planning to build your own cowl. Could be a big
project. The thrust line position is important for the airplane to
handle right. When you cob it if it is too high the airplane will
not pitch up at the right rate. If it is too low the airplane
will pitch up too quickly. You should stick pretty close to
what Piper had.

 Paul, I'm curious about your point on where the thrust line is. I'm no aero
engineer as you have probably guessed by now but I would have thought that
the thrustline vertical position is of minor importance within a few inches
on an airframe and that very small changes to the angle of the thrustline
would easily compensate for any vertical displacement. Not true??

On my high wing equivalent of a 170, I have close to 4 degrees more
downthrust than a factory 170 with the same engine. Surely this type of
variation is of much more significance than vertical displacement of a few
inches yet my machine handles fine.

Yes they would. But you should keep it as close to stock as possible.
Within a few inches is fine. Five inches and you are pushing it. As you 
pointed out the angle may be even more important. You also must worry 
about the deflection  of the rubber motor mounts. PL


Would anyone out there with the appropriate knowledge be willing to
"eyeball" some changes I plan to make to my tail and engine incidences
before I start cutting????
For example I want to eliminate the up elevator I carry in level flight as
well as improve take off performance by reducing downthrust. There are also
some Cof G anomolies. Any takers??? please...

The up elevator is necessary for stability and the amount is a function
of the CG position among other things. You are playing with fire here so 
be very careful. My advice is stick to the orginal design as closely as 
possible. Speaking of that who designed your airplane?
 
Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org