X-Mozilla-Keys:
Paul. Could a lightweight foam 13B be cast and sold to those in the
process
of mounting the engine. This should assist in getting everything in
proper
position with the need of engine hoist and bulky bracing. They could be
produced for less than $20 after the first one was created.
Archie wrote:
There is a company that makes "dummy"
plastic engines. Mostly V-8's, for mock up
display, or chassis fitting. May have a rotary.
However, I believe they sell for several hundred.
The company is called: Pay'R I believe.
I can research it if interested.
Archie
Paul Yaw wrote:
I used to mold foam for a living, and even still have some of the
equiptment. If I were to make these (And I wouldn't.) I would probably
want in excess of $100 each. The mold would have to be silicone (Or a
VERY intricate multi piece rigid mold.) and would probably only be good
for 50 parts or so. The entire mold with support and liner could easily
be a few weeks work if any accuracy was desired. The short story is
that they would be quite pricey in anything but high volume.
PY
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org