X-Mozilla-Keys:
Mike Wills wrote:
Maybe something like this can work for a majority of builders but I dont
see how you can come up with a "one size fits all" configuration
considering the different types of aircraft being built by the folks on
this list. I doubt that what works for the composite guys here is gonna fit
my RV4. Once you jump that hurdle then consider the different cooling
requirements depending on the expected power output for the different
installations. Some on this list are looking for 160HP others running 3
rotors or turbos are expecting 250+.
A while back I floated an idea for a standardized engine config. I'd like
to have an optimized normally aspirated 13B but cant afford to spring for
the necessary R&D for a one off engine. I assumed that since most of the
kitplanes on the market are powered by 4 cyl Lycs in the 150 - 200 HP range
that a lot of you would be looking for the same thing. Seemed to me that if
a few of us were in agreement we could pool resources and contract someone
like Paul Yaw to do the dyno work to develop a standardized intake and
exhaust system, port config, etc.. and then build X copies of that. Only
doing the dyno work once should save enough to make this cost effective but
I heard no response on that idea. Seems the standardized engine would be an
easier thing to realize than the standardized cooling config.
Mike Wills
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org