Subject: Consultant on heat exchangers.
From: Paul
Date: 12/10/1999, 10:02 AM
To: zz

X-Mozilla-Keys:                                                                                 
Marc Pedings wrote:

Paul wrote:

Mike Wills wrote:

  Maybe something like this can work for a majority of builders but
I dont
see how you can come up with a "one size fits all" configuration

I agree whole heartedly!  I was offering a start somewhere :-).  I have
been on
the list for over a year and figured that this would be an effective
start to a
'joint project'.  There is a wealth of talent and capability here.  I
figured
that we could take that a step further and combine some resources, some
issues
would be resolved. :-)

(snip)
  A while back I floated an idea for a standardized engine config.

I must have missed that post too.  Darn Winbloze...

I'd like
to have an optimized normally aspirated 13B but cant afford to
spring for
the necessary R&D for a one off engine. I assumed that since most of
the
kitplanes on the market are powered by 4 cyl Lycs in the 150 - 200
HP range
that a lot of you would be looking for the same thing.

I was assuming a start on a 180HP NA 13B.  But hey, why stop there? 13B
Turbo,
20B NA, etc...

Seemed to me that if
a few of us were in agreement we could pool resources and contract
someone
like Paul Yaw to do the dyno work to develop a standardized intake
and
exhaust system, port config, etc.. and then build X copies of that.

Yes.... :-)

Only
doing the dyno work once should save enough to make this cost
effective but
I heard no response on that idea. Seems the standardized engine
would be an
easier thing to realize than the standardized cooling config.

Very true.  I just figured that we could start somewhere and the
convenient issue
was:  Cooling.  :-)

Marc Pedings

Come on guys please clean these meassges up before you send them.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org