Subject: Tracy Crook's Redrive 100 hour inspection.
From: Paul
Date: 12/11/1999, 8:38 AM
To: zz

X-Mozilla-Keys:                                                                                 
Tracy Crook wrote:

Last week, at just under 100 hours, I removed my new redrive (I've named it
RD1, catchy name, no?) to determine if anything was going astray.  The Ford
C6 gears themselves are pretty well proven so the main things I wanted to
check were the pressure lubricated  plain bearings which are fed from the
engine oil system.  BTW, this is the main reason I use synthetic (Mobile 1)
oil in the engine.  It has better resistance to viscosity breakdown due to
heat and the high pressure loads imposed by gears.  Not much of a story to
tell here.  The bearings showed no signs of oil starvation and had no
measurable wear.  I was very careful to give all the plain bearings a width
to length ratio of well over .4 which is the minimum guideline reccomended
for bearings of this type.   Failure to observe this guideline was said to
be the cause of several bearing failures in the original Powersport gear
drive.  I think the new guys at Powersport have corrected this.

The other item of interest was the rubber isolators in the damper.  Several
people urged me not to use rubber for the damper but the only concrete
reasons any of them could offer were statements like "anything made of oil
will sooner or later return to oil".   I call this "engineering by cliche"
and I try never to do it.  Hell, the pilot is made of 98% water and I know
for a fact that he or she will definitely return to that form but is that a
reason not to fly?   In any case, the rubber isolators looked just like they
did when installed.   In the event that they should evaporate into thin air,
the redrive would still function due to the fact that they are totally
captured on all sides by the damper.  The only consequence would be a bit of
clatter when the engine was shut down.

The gears themselves looked fine.  100 hours is not long enough to make any
prediction on life for them but in a planetary drive, life is highly
dependant on adequate lubrication.   I took considerable pains to insure
that lots of oil got to the gear set by squirting it out of the small hole b
etwee two teeth in the sun gear.  Not my original idea; this is how Ford
does it in the transmission.

I'm very pleased with the performance at this point and have judged it good
enough to build for others.   There were only two changes made during
development.  The first was the addition of a second oil return line from
the area just in front of the rear main bearing.  I tried to return the oil
here via a drilled passage in the gear housing to the main return point
below the gear set but it built up too much pressure and caused the front
seal to leak.

  The other change was to go from a needle thrust bearing on the input shaft
to a pure thrust ball bearing (the three piece kind with separate races on
either side of the ball cage).   This was done for TBO reasons.  The needle
bearing looked like it would have a maximim life of about 300 hours (mainly
because of its rpm limitations).  The ball bearing has a much higher speed
rating and should go well over 2000 hours.

Tracy Crook
rws@altavista.net
www.rotaryaviation.com


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org