Subject: Stock Ford C6 35 mmm output shaft.
From: Paul
Date: 12/21/1999, 12:20 PM

Al Gietzen wrote:

I await some results on some real analysis of the adequacy of the smaller
output shaft.  I am not certain that 1.375" is OK; but I am quite certain
that comparisons with the output shaft diameter of an aircraft engine
crankshaft is pretty meaningless.  The loading situation with the prop loads
carried through a bearing to a piston crank is totally different than the
loads in a short shaft coming from a planetary gear set.

Al Gietzen

They both have to deal with similar gyro loads and they both have to deal 
with similar thrust loads. The pulse frequency through the PSRU as I reason
it out is four pulses per prop rev while a direct drive four
cylinder is two pulses per prop rev. The amount of torque variation
that gets through the vibration isolator/clutch disk or rubber bushings 
may vary with type and age or wear.  The amplitude of the pulse might be 
about half given the same HP. The rotary probably gets points as I think the
pulse shape may be better in the rotary than in, say, a Lyc O-360.

One could argue that the torsional resonant frequency of the 
small shaft is less than a large shaft and that would put it
below the pulse forcing frequency of the engine. Good luck! :-)

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org