"Kevin R. Walsh" wrote:
defl = (5 x W x l^3)/(384 x E x I)
Yes. For a simply supported, distributed load only.
l is the length in inches
W = w x l or the total load in pounds while w is the load per inch.
E is the modulas of elasticity for wood.
About 2,000,000 (Steel is 30,000,000)
Modulus of wood is listed as 1-2 E6 PSI. Check the exact number for
the wood you are using. Machinery Handbook should have the most
common.
I is the moment of inertia for the beam and is equal to
1/12 x height of the beam to the fourth power or I = 1/12 x h^4
I, for a rectangular beam, is 1/12 x bh^3. Your formula only
works for square beams. b is the width, h is the height. For I beam
or other sections you must calculate I.
=====
Kevin Russert Walsh
Process & Equipment Development Engineer
Thanks for correcting me on that Kevin. It has been years since
I used those formulas. I glanced in the book and took the first
one I found :-)
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org