Subject: Mr. IVO and his props.
From: Paul
Date: 12/22/1999, 11:36 PM

Howard Wilkinson wrote:

Paul:
    As I said the IVO doesn't change the same amount throughout it's length.
>From the bent end of the torsion rod to the tip is constant, from the bend
end of the torsion rod to the root pitch change is progressively less.
    Perhaps a more successful (broader range)  system might use a flexible
zone near the root in an area which would be covered by the spinner.  Thus
everything outboard of this zone would twist the same.  The problem of
course would be to carry loads through this zone.
    Props are relatively massive near the hub to resist bending loads.
Helicopter rotors on the other hand are designed to flex via lead/lag/flap
joints or articulate about a single point in the center as on many two blade
systems.  They can be built much lighter as a result.  Perhaps the proper
design using a reinforced elastomer near the hub would allow props to do the
same so that they could be much lighter.  and also allow pitching without
the fancy machined hub with all the precision gears and bearings.
    Mr Ivo's concept is great, but has it's limitations.......  For my
application it's fine..... My maximum straight and level speed is in the 70
mph range.  I love the simplicity.... the design has true greatness which is
always simple when speaking of engineering...... Perhaps it's time someone
extended the concept.
                                                        H.W.


Sounds like a really good idea Howard. It would reduce the loads on
the PSRU output shaft as well.

BTW do you have a sketch or some dimensions on that IVO prop
arrangement? I am thinking of somehow working it into my program.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org