Subject: IVO SPEC'S - Only the specs
From: Paul
Date: 12/23/1999, 7:46 PM



Jim wrote:

For anyone interested, the IVO prop spec's are:

For engines up to 700hp
30"-90" or 45"-105" pitch range
58"-76"diameter

Based on the pictures, I would 'GUESS" that the base pitch is the low number
for each prop.

Actually, the neutral base pitch for these props is half way in the range. IOW,
it twists the blade both ways from the neutral position. Without any load on the
torsion rod, the blade pitch would be either 60", or 75"(deep pitch).

The thing about IVO in-flight adjustable props is that they are very light (27#)
compared to a normal CS prop (50+#), plus they cost only slightly more than a 3
blade wooden prop (about $2K). For most experimentals (engine), you can't supply
the hydraulic oil pressure necessary for a CS prop, nor can you accept the
additional weight. An electrically controlled Hoffman or  MT costs about $10K
which is too much.

An adjustable prop let's you get off the ground and climb, even when fully
loaded, plus gives you better  top end cruise.  IMHO, if we can figure out how
to make this prop work reasonably well, it's a great advantage over a fixed
pitch setup. Chuck Harbert

Guys I need the blade angles in degrees along the blade length. 
Not the pitch in inches.

With an IVO it is tough to convert because the twist is almost
never the same for the pitch in inches. I am sure those pitch
numbers from IVO are an equavalent pitch or just a guess.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org