Bill Freeman wrote:
One additional point. My guess is that we can get away with a lot of
potentially
dangerous 'under-engineering' of prop shaft, bearing and flange systems
when we
use these **VERY** light weight wood props. As soon as we put on a
metal prop,
or even worse a variable pitch metal prop, my view is that you had
better
have an
*extremely* stiff and strong (note that these are separate things,
folks)
propshaft
system or you are going to have difficulties that might get you hurt.
The
loads with
a 7 lb prop where 70% of the wt is within 6" of the hub is *very*
different
from
a 50 lb prop with half the wt in the blades. Think about this before
you
convince
yourself that you must have a variable pitch prop. The extremely light
wt and
natural internal damping of wood props has probably saved many, many
homebuilders
from injury.
Take care.
Bill
Tracy Crook wrote:
I fully concur with Bill. I specify that my redrive be used with wood or
light weight composite props. On top of that, I recommend against using
any prop extension. The long nose of the drive should make this unnecessary
anyway.
Recreational aerobatics should be no problem if these guidelines are
followed ( I get upside down on virtually every flight). If you are into
competition level aerobatics (which would give the rapid pitch changes
discussed earlier), this is all a moot point. To quote my conversion
guide, "The wise test pilot only pushes one edge of the envelope at a
time". At this point in time, you'd have to be nuts to mix an experimental
engine installation and competition aerobatics.
I must admit that I'm amazed at the apparent lack of prop shaft failures in
any of the redrives out there. There are some (any belt drive with
cantilevered pulleys) that I would give up my seat in the electric chair to
fly. It appears that the stresses are not as high as many fear.
Tracy Crook
rws@altavista.net
www.rotaryaviation.com
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org