Subject: Mantyla plans built PSRU
From: Paul
Date: 12/24/1999, 10:01 AM

Marv loaned me his set of plans and asked me to comment.
It looks pretty good over all. A minor improvement would
be to bolt the output flange to the output shaft using a taper
instead of a simple shoulder as shown here. Tapers have
better stress distribution in this area. Another improvement
would be to do away with the large adjusting nut, spread
the bearings out more to better resist gyro prop loads
and use a crush bearing spacer such as is commonly used
in automotive rear axles. These are minor changes in the
over all scheme of things however.

BTW the shaft diameter of 1.772 Jim Mantyla is using is about
2-1/2 times stronger than the 35 mm (1-3/8) Ford C6
shaft. Jim's shaft is about the same strength as the Ross
output shaft. It probably could stand boring out to save
a bit of weight.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

mantpSRU.JPG