Charlie and Tupper England wrote:
snip>
Also BTW there are two issues putting the bearing close to the prop.
Putting the bearing close to the prop does not change the prop gyro
bending loads on the prop shaft. They are still there and they are
high. This is a common mis-perception.
All it does is reduce the wipping effect of the run-out in a poorly
machined prop shaft extension. The prop gyro bending loads are the
same.
Paul Lamar
I'm no physicist, but it seems that if you give the gyro bending force a
6" lever, it can push a lot harder than with a 1/2" lever.
Charlie
Yes, it is kind of counter intuitive. The gyro forces are a pure moment
or torque and not a translation force. Get a toy gyro and fool around with it.
You can translate it (lateral movement) until you are blue in the face
but there will be no torque generated. Twist it on the other hand
and you will have a hard time holding it.
A top is a another good example. A spinning top will move all over
the table top (translate) with out falling over.
In a pitch acceleration situation the weight of the prop itself
causes a small bending moment on the shaft if it is overhung by
a significant amount but this is a very small torque or moment compared
to the gyro forces caused by a pitch velocity. This, in fact, is what leads
to wip and is why a prop extensions needs to be very stiff.
Wip is caused by the CG of the mass of the prop being away from
the axis of prop rotation. Centrifugal forces on the CG of the prop
then takes over and trys to bend both the prop extension and the crankshaft.
The CG of the prop can move away from this axis slightly if a
pitch accleration should occur.
I am sure all this is as clear as mud. :-)
The simple and sure thing to do is get the bearing close to the
prop and make the shaft plenty strong!
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org