Also BTW there are two issues putting the bearing
close to the prop.
Putting the bearing close to the prop does not
change the prop gyro
bending loads on the prop shaft. They are still
there and they are
high. This is a common mis-perception.
All it does is reduce the wipping effect of the
run-out in a poorly
machined prop shaft extension. The prop gyro bending
loads are the
same.
Paul Lamar
Vance Jaqua wrote:
Altho the gyro moments are the same - the reslting
radial forces on the bearings are reduced -and that ia
worth quite a bit - Vance
Yes I agree. Good point.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org