Jim Mantyla wrote:
Hello Group,(paul?)
One of the considerations in designing my drive was to make it as short as
what could be considered to be reasonable.Should someone wish to increase
the bearing spacing it would be a simple thing to do.For the horsepower and
prop sizes i am using the bearing spacing has proven to be adequate.This was
designed in conjunction with the SKF engineering staff.
Hope this gives some insight ito my thought proccess when I was designing
this drive.
Jim Mantyla
Jim Sower wrote:
I guess I'm lost here. Why make the the drive as short as practical when everyone
seems to be spending big bucks on 4"- 6" prop extensions (that create tracking
problems and much larger moments/loads on whatever bearings exist in the drive
train)? Why not make a longer PSRU, put a bearing as close as possible to the
prop and unload pretty much everything? What am I missing?
Just a theory, Jim S.
Nothing Jim you are right on. There is a slight weight issue however.
Also BTW there are two issues putting the bearing close to the prop.
Putting the bearing close to the prop does not change the prop gyro
bending loads on the prop shaft. They are still there and they are
high. This is a common mis-perception.
All it does is reduce the wipping effect of the run-out in a poorly
machined prop shaft extension. The prop gyro bending loads are the
same.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org