Harry Sheldon wrote:
Also, do you have any info on wieght reduction components/aftermarket
for rotary engines.
Thanks and regards,
Harry Sheldon
Also Harry you could make your own if you have access to a mill.
Here is a suggestion on making your own housings. I would guess
0.125 thick 4130 heat treated and ground flat steel plate ought to work
for the endhousing wear surface. If using the late rotor housings
the O-ring groove should go in the steel plate rather than the
rotor housing.
Get some old housings and cut them apart. Copy the water passages exactly.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org