Subject: Aluminum end housings.
From: Paul
Date: 2/1/2000, 4:29 PM

npeckler wrote:

Paul,

Ideally, how much would be saved with aluminum end housings.  Did you say
the Aluminum end housings weigh in at 35 to 40 lbs? Or is that the cast
Iron?

The cast iron weigh 35 to 40 lbs. Weight with the steel plates?... probably about
half. Roughly 50 pounds. That would put a two rotor with PSRU under
200 pounds.

Certainly 16 lbs does not sound like much for the steel plates.  Is anyone
operating all aluminum rotaries?  Are the Norton's all aluminum?

Yes. See the Midwest Engines link on the ACRE NL web site.

You  mentioned Felix in Germany in the present tense.
Are or were they going for all aluminum engines.

Felix is dead. Wankel GmbH all aluminum. See the ACRE NL web site
for a link.



 Just reading a letter from the plugs up newsletter (Howard Wilkinson"
<owly@mcn.net) This guy was investigating aluminum end housings.  I'll keep
reading.  How successful are the Racing beat housings?

Jim (Racing Beat) has been working on these for ten years.

Is it just the wearing surfaces that are the problem?  Seems like there are
a lot of wear resistant coatings on the market.  Nicosil?

Used by Wankel GmbH.


What would an all aluminum engine weigh in at with all the present light
weight parts that are available?  Include all systems and fluids.  Are we
talking close to 200 lbs?  

Firewall forward 250 pounds with everything. 300 pounds with cast iron 
end housings. Roughly.

Seems that was what the Hatch all aluminum engine
came in at.  (180 lbs) I don't know if that was with or without accessories
and fluids.  Why did they return to cast iron?

Too expensive.


Noah

PS sorry for all the questions, but a light weight rotary seems achievable.

BTW the steel plates allow an easy overhaul unlike nicosil on aluminum.

Paul Lamar

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org