Subject: Aluminum end housings.
From: Paul
Date: 2/2/2000, 6:31 AM

We are going top break this up in smaller peices for clarity.


Paul Lamar wrote:
Steel is three times stiffer than aluminum and twice as stiff as cast iron.



grobbins wrote:

Cross section and construction effect the final results.


Would internal pressures dynamically warp, or "oil can", the steel with an
open  sided, cast aluminum side housing ?


Paul Lamar wrote:
You are not going to oil can a crescent shaped  piece of 1/8 thick steel
three inches wide at it widest point and six inches long with combustion
pressure. Besides that it is supported by the required water jacket
baffles.
Paul Lamar

grobbins wrote:

I'm talking about the whole housing, across it's roughly 8"x12" oval bolt pattern, with
a 2-1/2" hole in the middle. I don't think that 1/8" steel plate is anywhere near as
stiff, across the bolt pattern, as the 1-1/2" thick original 1pc hollow casting.


Paul Lamar wrote:
That is kind of not relevant isn't it? We are talking a sandwich here. It is
bolted to a rotor housing. The three inch thick rotor housing is very stiff
in bending.



grobbins wrote:
The 3" thick rotor housing does not help as much out in the middle of the plate.

I repeat. There is no load on tthe center of the plate so this test ie meaningless.
The pressure load is near the edige of the rotor housing.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org