Subject: Aluminum end housings.
From: Paul
Date: 2/2/2000, 6:53 AM


Paul Lamar wrote:
This is not relevant to what we are talking about here. If you take this
same piece of steel and bolt stiff collars, two inches wide and three inches high
all around the  out side edge on both sides of the steel plate the situation will
change drastically.


grobbins wrote:

It will. But the pressures (of a running engine) will be drastically different too.

Paul Lamar wrote:

In what way will the pressures be different than 800 psi?



grobbins wrote:
The configuration of the aluminum backing the
steel up isn't much better.

Why not? P.L.


The stationary gear and main bearing holder are in the middle of a single wall aluminum
casting. Grant 

Not true. The support is both from the steel plate and the NC milled billet
aluminum water jacket. P.L.

What else supports them but some crooked baffle walls attached on 1 side only, that
rarely extend all the way across. If they were made thick enough to be as stiff 
as iron, they would be much heavier.

Aluminum is one third the density of iron. So they could be up to  three
times thicker and not be as heavy. These baffles are primarily in compression
and as such they are very stiff short columns. We have, sort of, a honeycomb 
composite beam here. One flange or skin is steel with three times the stiffness of 
aluminum and the the other flange or skin is aluminum. We are not comparing
this structure to a cast iron end housing. We are comparing it to an aluminum
end housing which has proven to be adequate. As such the equivalent wall 
thickness, as far as stiffness is concerned, to the 1/8th steel plate is 
a 3/8 thick aluminum wall. The aluminum end housing that I have seen
for the Mazda rotary  only have about a 1/4 inch wall.

Paul Lamar


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org