Subject: Aluminum end housings.
From: Paul
Date: 2/2/2000, 7:04 AM

grobbins wrote:

At WOT with a turbo, combustion pressure across the combustion portion's limited area
would add up to significant total pressure, at least in the combustion area.

Yes, perhaps 800 PSI as I recall and that is when the exposed side wall is of
minimum area. Perhaps less than a half inch wide. As the chamber gets bigger
the pressure rapidly drops off. The load on the rotor face is way higher
than the load on the end housings. P.L.


That loud noise you hear coming from the exhaust is residual pressure still in the large
expansion area when it finally vents. At the end of the expansion phase, we have one of the
larger exposed side housing areas. If residual pressure were only 25 lbs (probably much more
at WOT), that times the large exposed area of the side housing at that point add up to a
sizable deflection pressure number. This pressure area is also closer to the center, the
deflection area in question. The rotor sees near the same combustion PSI as the rest of the
exposed surfaces at any given instant, only the areas are different.


Let us say for the moment the area in question is a triangle 2.5 inches
high by six inches long. I placed the rotor in the rotor housing and measured this.
The average area of this triangle is 7.5 square inches. At 25 psi the side force
on the steel plate is then 187 pounds applied 1.75 inches away from the rotor
housing and about 4.5 inches away from the center of the plate. Actually it is not
even this bad as the load is distributed.

I am done with this. It will work. 

Paul Lamar


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org