Bill Marvin wrote:
I was playing with the math for the motion of a Mazda rotary and found that
there are several stationary gear/rotor gear ratios that would create a
defined/repeated path for the apex points on the rotor to follow. I created
a simulation of a 2 sided rotor just to see what it would look like in
motion. The attached file is a video clip that runs in "Windows Media
Player". This rotor has a gear ratio of 1:2 where the 3 sided rotor (as in
all rotaries I've seen) has a ratio of 2:3 (stationary gear : rotor gear).
This would most easily be a "2-stroke" rotary since each combustion chamber
goes through only 2 volume changes each time the chamber travels around the
360 degrees of the housing. The standard rotary has 4 volume changes of
each combustion chamber for each cycle around the housing. This motion has
a very large potential compression ratio. The ratio would be easily set
simply by when the intake port closes. I don't know much about diesels, but
could this work as a diesel engine?
Other gear ratios can produce 4,5,6,7,... sided rotors. As the number of
sides increases, the maximum compression ratio goes down and the number of
volumetric changes per cycle around the housing goes up.
Just a wild idea :). Any comments?
Bill Marvin
Can you send that as an animated gif Bill?
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org