Subject: Aluminum end housings.
From: Paul
Date: 2/5/2000, 2:52 AM

Barry Gardner wrote:

Paul,

I think you should point out to Bob that the two part
steel-aluminum sandwich being discussed would be a replacement
for the OEM *cast iron* housings (not "aluminum factory piece").
There *are* aftermarket aluminum end housings available from
Racing Beat but they have the disadvantages of high cost, tricky
wear coatings, and likely limited life.

Bob will otherwise be confused if he thinks that you propose
substituting steel for aluminum and end up with a 50 lb saving.
That's a counter-intuitive trade-off.

Barry Gardner
Wheaton, IL

Good point. It is late for me :-)

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org