Richard Sohn wrote:
An important function seems to have been lost in the aluminum end housing
discussions. I mean the heat transfer through the inner wall to the most
part of the cooling fluid pockets inner surface. Not only do you not want
any insulation, you certainly need to have unrestricted heat transfer from,
say an inner steel plate to an outer aluminim housing. Incidental metal
contact may not be enough.
Just one more thing to watch out for.
Richard Sohn.
A very good point Richard. Here is a chart from Taylor of the temp drops from
a combustion chamber through a cylinder wall into the coolant. The steel plate in my
suggested design would act like a wet cylinder liner.
The chart shows that the major resistance's to
heat transfer is the gas or liquid film that develops on both sides of the wall.
This is why it is important to have turbulence in the water jacket to scrub this
film off the wall. As one can see by the temperature drops the metal heat
conductivity
plays a minor role. Cast iron works in an engine almost as well as aluminum. The
two materials have very different conductivity's.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org