Jeff Spitzer wrote:
At 08:10 AM 2/6/00 -0800, you wrote:
Richard Sohn wrote:
An important function seems to have been lost in the aluminum end housing
discussions. I mean the heat transfer through the inner wall to the most
part of the cooling fluid pockets inner surface. Not only do you not want
any insulation, you certainly need to have unrestricted heat transfer from,
say an inner steel plate to an outer aluminim housing. Incidental metal
contact may not be enough.
Just one more thing to watch out for.
Richard Sohn.
A very good point Richard. Here is a chart from Taylor of the temp drops from
a combustion chamber through a cylinder wall into the coolant. The steel
plate in my
suggested design would act like a wet cylinder liner.
The chart shows that the major resistance's to
heat transfer is the gas or liquid film that develops on both sides of the
wall.
This is why it is important to have turbulence in the water jacket to scrub
this
film off the wall. As one can see by the temperature drops the metal heat
conductivity
plays a minor role. Cast iron works in an engine almost as well as aluminum.
The
two materials have very different conductivity's.
Paul Lamar
I've largely been ignoring the discussion on the "Lamar Liner" until now.
Just one small problem: There is heat flux across the plate, therefore
there is a temperature gradient, therefore the plate wants to bow inward.
If the plate is not attached to the backup structure it will fail. If it
is attached to the backup structure the large difference in CTE between the
aluminum and steel will be a problem...and it will fail. Maybe there's a
reason why no one else has done this....
Jeff Spitzer
Good point. Use over size tension bolt holes in the steel plate and let the
aluminum expand independent from the steel plate. I will calculate the difference
soon. I will also calculate the bowing effect as I am sure there has been some work
done on that. What temp do you feel the plate will run at?
I still think it is preferably to a thin nic-a-sil coating as once that
goes the seal could dig into the soft aluminum end housing and fail the
engine catstrophically.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org