I've got two question's about Tracy Crook's fuel injection setup in
regards to vapor lock problems-
1. Does the increased fuel pressure required for fuel injection
eliminate or greatly reduce the problem of vapor lock?
Thanks
Brian Trubee
Redmond, Wa
Mike Wills wrote:
IMO the volume of fuel passing through the system should eliminate the
potential for vapor lock as long as the return fuel is brought back to the
main tank. If using a sump/header tank with return fuel to the header, the
header should be large enough to allow the heat picked up in the engine
compartment to be dissipated into fresh fuel from the main tank. Someone
else also pointed this out.
This was discussed here about a year ago. One design proposed involved
using a single high pressure pump for each wing tank. The pump outputs are
brought together into a "T" and the output of the "T" feeds the fuel rail.
The return fuel is brought back through a conventional fuel selector (or an
automotive electric selector) to return to the tank it came from. SO there
is no selector valve for the fuel supply, only the return. This scheme
relies on the built in check valve that is commonly found in most EFI pumps
to prevent transfer form one tank to the other.
As I recall, the only potential problem that was pointed out with this
kind of scheme was that if one of the pumps fails, you lose access to that
fuel. What are the odds of failing a fuel pump in one tank and having the
other tank empty? This could be overcome by having provision for an
emergency crossfeed that would allow moving fuel from one tank to the other
if necessary.
I like the simplicity of this approach. If used with an electric valve
for return switching, switching tanks can be accomodated by use of a single
switch, reducing pilot workload and potential for error. In fact switching
fuel could be totally automated (with a manual override of course) so that
the pilot doesnt have to worry about remembering to switch tanks. Does
anyone see any other potential flaws with this setup?
Ive also considered Tracy's system. It too is very simple. As I recall
from one of his newsletters, on one flight he did forget to turn off his
transfer pump and he pumped an unknown amount of fuel overboard through the
vent. If using a system like this it may be worthwhile to incorporate a
simple float switch that disables the transfer pump when the left (engine
supply) tank is full. Im also considering using this system.
Mike Wills
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org