Jeff Spitzer wrote:
I've largely been ignoring the discussion on the "Lamar Liner" until now.
Just one small problem: There is heat flux across the plate, therefore
there is a temperature gradient, therefore the plate wants to bow inward.
If the plate is not attached to the backup structure it will fail. If it
is attached to the backup structure the large difference in CTE between the
aluminum and steel will be a problem...and it will fail. Maybe there's a
reason why noone else has done this....
Jeff Spitzer
That last word should have been catastrophically. Robin walked in an told me I was
going to be late for my doctor's appointment :-).
I don't think this problem will be anywhere near as bad as you make it out to
be Jeff. After all the rotor housing has a steel liner and it runs a lot
hotter than the end housings and so far nobody has reported a thermal
stress induced failure in the rotor housing.
One of the compensating factors is the steel will probably run hotter
than the aluminum part tending to equalize the expansion. The steel has a lower
coefficient of thermal expansion (CTE) than the aluminum of course. It would take
a thermal FEA to figure all this out. In any event I doubt the steel will run
hotter than 300 F while the aluminum should be 210 F or so. Not a huge difference.
I think one of the reasons it has not been tried so far is it is labor intensive and
more expensive in high volume production than coated aluminum. More parts and more
O-rings.
Not a problem for a hand made aircraft engine.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org