Subject: Two part Aluminum end housings.
From: Paul
Date: 2/7/2000, 11:55 PM

npeckler wrote:

Paul,

I have been listening to all the threads concerning the Aluminum end
housings.  The advantages to the all aluminum end housings are ultimate
light weight.  The disadvantages are the need for a high tech, low friction,
high wear resistance coating.  When the service life has been reached, then
either resurfacing or replacement of the end plate needs to take place.  I
am a CNC machinist that is currently going through a steep learning curve
concerning the inserts used in the cutting tools and the various coatings
and grades that exist.  The coatings field is exploding and would not be
unrealistic that decent coatings could be located in short order.

Paul, your idea of using a flat steel plate between the rotor housing and
the aluminum end plate has intrigued me for some time. Your plate concept
addresses problems with manufacturing the all aluminum housing, problems
finding affordable coatings, as well as refurbishing worn units.  I have
always been uncomfortable with the complexities of additional sealing
problems.  Certainly not imposable to come to grips with, yet a lot of
additional surface area to seal and potentially leak.

The answer:

No, maybe I'll wait. One more week of squabbling is my sort of cheep
entertainment.  OK, OK lets compromise.

I have some Gourmet pots and pans that are laminates of different types of
metals.  I have some aluminum pans that are fully lined with stainless
inside.  I also have a solid copper pan with a full stainless interior. I
have gone through the process of trying to reverse engineer these pans.  Do
they take prelaminated sheet and form them?  The only way I have been able
to solve it is to form the stainless and pour the aluminum around it, then
machine the OD.  Now for pots and pans there has to be a simple way of
forming prelaminated sheet to keep costs down.  The second method is
unacceptably expensive for pots and pans.  But not for end housings.

Some aviation pistons have steel ring lands molded into the pistons.
Aluminum was poured with steel rings locked in the molds.  Laser cut some
sort of steel plate with water passages and needed ports and bolt holes, pin
register to mold and pour in the aluminum.  I suspect that the steel can be
pre ground to add surface area for a good mechanical bond to the poured
aluminum.  The steel side can be surface ground to reflaten.  It can be
reground several times with use of different thickness gaskets.

The cost and complexity of this does not seem unusually difficult.

Lets hear some criticism.  Take your best shot.  Those who offer
constructive criticism will be able to buy end housings at substantial
discount or even at cost.  Any obnoxious criticism that gets my goat, can
fly their aircraft with the added ballast of well proven cast iron end
housings.     :-)

Noah

As I recall if you really clean the dissimilar metals well and press them together
in a vacuum with real high pressure they will weld themselves together. This
is a real vague recollection of mine from perhaps 30 years ago. I could, of
course, be way wrong. It may be only practical to do this with sheet material
such as pots and pans are made of.

One could always machine the back side of the steel plate with T slots sort of
and cast the aluminum around it. That is exactly what Mazda does with the rotor 
housings. Problem is cost of machining those T slots. Mazda must have some
sort of tooling to roll it into the hot steel at high speeds and low cost.
Perhaps a few inquiries to a steel sheet fabricator might prove fruitful.

Low cost aluminum end housings would really put the Mazda rotary engine on
the map of aircraft engines.

Paul

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org