tcarrico wrote:
<snip>
Some aviation pistons have steel ring lands molded into the pistons.
Aluminum was poured with steel rings locked in the molds. Laser cut some
sort of steel plate with water passages and needed ports and bolt holes,
pin
register to mold and pour in the aluminum. I suspect that the steel can
be
pre ground to add surface area for a good mechanical bond to the poured
aluminum. The steel side can be surface ground to reflaten. It can be
reground several times with use of different thickness gaskets.
The cost and complexity of this does not seem unusually difficult.
Lets hear some criticism. Take your best shot. Those who offer
constructive criticism will be able to buy end housings at substantial
discount or even at cost. Any obnoxious criticism that gets my goat, can
fly their aircraft with the added ballast of well proven cast iron end
housings. :-)
<snip>
Low cost aluminum end housings would really put the Mazda rotary engine on
the map of aircraft engines.
Paul
I think the NC version of the aluminum is more advantageous. To cast the
alminum
onto the Lamar Liner would put you back into worrying about core shift and
all
the other problems associated with molding internal cavities. You will have
to
increase thicknesses to account for inadequate control, and add weight. The
NC
version should be lighter just by virtue of more control over wall
thicknesses.
You could mold a female cavity onto the liner, and then machine it on an NC.
Aluminum plate and O-ring to seal it up and you have moved your seal from
the
liner to the outermost part of the engine. More effort than the pure NC
approach. You would be adding two O-rings with the machined approach.
ramblings of a non-engineer....
tc
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org