Subject: Two part Aluminum end housings.
From: Paul
Date: 2/9/2000, 2:37 PM

One could always machine the back side of the steel
plate with T slots sort of
and cast the aluminum around it. That is exactly
what Mazda does with the rotor
housings. Problem is cost of machining those T
slots. Mazda must have some
sort of tooling to roll it into the hot steel at
high speeds and low cost.
Perhaps a few inquiries to a steel sheet fabricator
might prove fruitful.

Low cost aluminum end housings would really put the
Mazda rotary engine on
the map of aircraft engines.

Paul

Vance Jaqua wrote:


The lost styrofoam process is gaining favor in the
manufacturing of those funny engines with pistons.
Saturn has used this process extensively for near net
aluminum blocks and heads. This process elimnates
complex core boxes etc and you can bond foam sections
with trapped volumes (you at least need a hole to get
the sand in ). It is easy to find people to pour 356
alum castings You might explore this, Also you can
include other metals in or attached to the foam - I did
this for a small cannon with a steel tube bore - Vance



The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org