Subject: Fuel system design - new idea.
From: Paul
Date: 2/11/2000, 8:00 AM

Charlie Kuss wrote:

  Continue the straight sides
of the "T" connectors to the separate fuel rail for each rotor.  Using two
pressure regulators (one per rail, which is also one per rotor), plumb the return
back to the corresponding fuel tank, preferably at a distance away from the fuel
injector pump.

Goals met:

  1. Single fuel pump failure cuts fuel to half of engine, but engine keeps
     running.  Energize cross connect valve to pump fuel to both halves of
     engine.  Takeoffs could be made with cross connect valve energized so that
     reaction time is eliminated.

Russell,
 I am leery of all this over complication to the fuel system. Every item added to the
system adds another point of failure. If an item fails on your system, the other side of
the system is of little use, IF the fuel tank on that side is empty or near empty. This
will reduce the effective SAFE range of the ship.
 That said, I would like to suggest that you can improve your idea by NOT separating the
fuel rails by rotor. The 13B has 2 fuel injectors per rotor. A safer method would be to
feed BOTH primary injectors off of one fuel rail and the secondaries off of the other
rail. A failure with this setup would result in a loss of power of less than 50% and
would allow much smoother operation in the "limp home" mode.
Charlie Kuss


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org