Subject: Fuel system design - new idea.
From: Paul
Date: 2/11/2000, 8:02 AM

Gary Palmer wrote:

Russ,
        May I suggest a slight modification to your concept that would be even
simpler.

        Split the two high pressure pumps to the two separate FI rails; one to the
pair of primary injectors, and the other to the pair of secondary injectors. In the
event of failure of one of the pumps, you simply switch Tracy's controller into
injector failure mode for the appropriate injector pair. If I recall correctly
(IIRC) this increases the duty cycle of the remaining operational injectors to
maintain enough fuel flow for at least 80% power.


        This approach eliminates the cross-over valve. Coupled with a couple of
pressure switches, one per rail, and some relay logic, or even a built in
enhancement to the EC2, the pump failure and mode switchover could be automated.

        While I had planned a simpler system exploiting the normal Lancair header
tank in my 235, this approach has the appeal of getting fuel out of the cockpit,
and moving my CG back to compensate for the higher weight of the 13B compared to a
Lyc O-235.

Regards.........Gary

  Gary L Palmer
   Email: gpalmer@nortelnetworks.com

_____________________________________
   President, EAA Chapter 245
   Builder, Lancair 235 C-GPLM
 ___________________________________

Too cold to vist when I was up there last month Gary :-)

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org